Felt-Front Menu board with Corner Slots and Engraved Plywood Back (P23)

Felt-Front Menu Clipboard with Corner Slots — A Simpler Way to Hold a Single Page

Not every venue needs a multi-page binder. A single-sheet menu, a daily specials card, or a drinks list often works better on a flat clipboard that a server can hand over or set on a table without any bulk. The MC01 is built for exactly that: a felt front panel with four stitched corner slots that a printed page slides into directly, backed by a solid plywood panel that keeps the whole piece rigid and easy to handle.

Corner-Slot Mounting Instead of Rings or Straps

Rather than punching holes or fastening a spine, the MC01 holds its page with four felt corner pockets stitched into the front panel — slide a corner into each pocket and the sheet sits flat and secure, held only at its edges. Swapping a page takes seconds, and because nothing punches through the paper, a venue can print or reprint a single sheet without needing pre-punched stock. It's the most direct version of a menu holder we make.

A Felt Front Left Deliberately Unbranded

The front-facing felt panel carries no patch, no emboss, no printed mark — its job is to frame and protect the page, not to compete with it for attention. The soft, matte texture gives the clipboard a tactile quality that a laminated sheet or bare acrylic holder doesn't have, while staying visually quiet enough that the printed menu or specials card underneath reads clearly the moment it's picked up.

An Engraved Plywood Back Across the Full Inko HoReCa Palette

Branding lives on the reverse: a logo or wordmark engraved directly into the plywood back panel, permanent and resistant to the wear that a printed sticker would pick up from regular handling. The plywood itself is available across the full Inko HoReCa range — Oak, Walnut, Cypress, Rosewood, Wenge, Chili, Jeans, Olive, and Ivory — so the back panel can be matched to your dining room's existing wood tones or your brand's palette.

Light, Flat, and Easy to Hand Over

Because the MC01 holds only one sheet, it stays thin and light — easy for a server to carry table to table, easy for a guest to hold without the weight of a bound folder. That makes it a natural fit for single-page wine lists, cocktail specials, brunch menus, or any format that's printed fresh rather than laminated for the long term.

Made to Order, Made in Ukraine

Each MC01 is produced to your chosen plywood tone with your logo engraved on the back. Vector artwork (.ai, .cdr, .eps, .svg, .dxf) gives the cleanest engraving result. Production runs 5–7 business days with no minimum order quantity, so a single clipboard for a pop-up event is as straightforward to produce as a full front-of-house set.